Firmware update |
It takes time to set SP / HP power mode and serial transfer rate saved in internal ROM.
Version upgrade contents Update of sound source firmware Improve latency.
Time from Key ON to pronunciation improved.
It is not good at tongue mouth.
Other improvements in detailed processing.Speaker power mode Turn speaker output ON / OFF.
It takes about 1 second to store the state in the built-in ROM.
When set to ON, the volume value is set to the maximum (0 [dB]).
OFF at factory shipment.
It is assumed to be used on a module board.
There is no dedicated connector on the shield board.
Volume can be heard in a quiet room.Headphone power mode Turn on / off headphone output.
It takes about 1 second to store the state in the built-in ROM.
When set to ON, the volume value is set to the maximum (0 [dB]).
ON at factory shipment .Speaker/Headphone volume Set volume of speakers and headphones.
MUTE, -30 [dB] to 0 [dB].
It takes a little time to set the output stage IC.
Therefore, it is desirable to set it at the initial stage of play.Speaker/Headphone
request and responseCheck the power mode status of the speakers and headphones. Serial transfer rate
Exchange, Request, ResponseSet the serial transfer rate and check the status.
31250 [bps] or 38400 [bps].
It takes about 1 second because setting is saved in internal ROM.
Factory setting is 31250 bps.Note-on cancel Tone generation cancel channel specification.
Therefore it is desirable not to change frequently.
The speaker dedicated terminal does not exist on the shield board.
Moreover, the volume is about the level to listen indoors.
License
Please confirm and agree the contents of the software license agreement and the guidelines for using this product using NSX-1.
Download
[Download eVY1 Updater]
Sorry, updater is only Windows version.
![]() |
Copyright (C) 2013, Aides Technology Co.,Ltd. All Rights Reserved. |